CISCO Aironet Config

This only needs to be on the root bridge as the non root with never
allow any thing to association to it. So lets remove on the non root.

access-list 700 permit 0013.6011.7e90 ffff.ffff.ffff
access-list 700 deny 0000.0000.0000 ffff.ffff.ffff

-OR-

Mac authentication association with device(s) in its 'local list' of mac
address.
And we will enter just one 0013.6011.7e90 on the root bridge.

Remove the filter list off of the root bridge.
Start with non root first.
Only change needed here is to change the authentication method used by
the ssid. click on SSID Manager and then from this page, highlight your
ssid and then use the pull down box next to open authecntion and select
with Mac Authentication and then apply this change.

And on the Root Bridge, enter the mac address of the non root:
0013.6011.7e90
Under the Security section and then under Advance Security.
Enter the mac in the New MAC Address box and then click apply.
Then click on SSID Manager and then from this page, highlight your ssid
and then use the pull down box next to open authentication and select
with Maca Authentication and then apply this change.

3 more changes on the root.
1) From the SSID Manager page, scroll down to the bottom and check mark
the box for the Force Infrastructure client, then apply
2) Same page almost same spot unselect your ssid from the guest pull
down box. And then apply, this will broadcast the ssid, not need in a
point to point bridge link.
3)Data rates are currently set to best range. Lets match them with the
other side and select Default data rates under the Interface Setting
Page.

Globalink Tech Support
http://support.iglobalink.net